PTO and Pump Electrical Controls 54.38 General Information General Information Normally open AMU solenoid —Allows air to flow until power is applied to the solenoid coil. A PTO (power takeoff) and pump controls are op- tions that can be ordered for a Business Class ® M2 vehicle at the time the vehicle is ordered, after the vehicle is delivered, or when buying a used vehicle. Pump —Also called a split shaft PTO. The main driveshaft is "split" by the PTO. The PTO is actually a transfer case. PTO Controls A vehicle with a Mercedes-Benz AGS 1 transmission must have PTO controls installed via the M2 electri- cal system.
This is because the AGS electronics re- quire some messages to be broadcast to disengage the clutch from the flywheel so that the PTO mecha- nism can be engaged, and then to engage the clutch on the flywheel after the PTO mechanism is en- gaged. If the vehicle has a Mercedes-Benz AGS transmission and is not equipped with PTO controls, see Section 54.00, Subject 110 , for instructions on adding a feature. The PTO controls include two types of electrical de- signs. The controls for air shift PTOs drive an AMU or AAVA solenoid. The controls for hydraulic shift PTOs drive a relay. Hydraulic solenoids require about 1.5 amps of current to engage a PTO mechanism.
Pump Controls The pump controls comprise a single electrical de- sign. Two solenoid outputs are used to shift the transfer case. One solenoid provides air when the feature is activated (normally closed). The other sole- noid turns off the air supply when the feature is de- activated (normally open). A vehicle that is equipped with a transmission other than a Mercedes-Benz AGS is not required to use Freightliner PTO controls. PTO controls can be wired around the Business Class M2 electronic controls. A vehicle with an Allison automatic transmission and body builder-installed PTO controls must have the transmission controller’s PTO request input circuit connected to the activation switch.
PTO and pump controls use low-current outputs and digital inputs on the chassis module at the C5 electri- cal connector. Feedback from the PTO or pump mechanism is re- quired for correct operation of the PTO and pump controls. Feedback is provided by a ground input to the chassis module. A grounded feedback circuit indi- cates that the system is activated. An open feedback circuit indicates that either the system is not acti- vated (PTO switch is not turned on), or there is a malfunction (PTO switch is turned on). Definitions Air shift PTO —Air pressure is used to shift the PTO mechanism. Hydraulic shift PTO —Hydraulic pressure is used to shift the PTO mechanism.
This is usually only avail- able with an automatic transmission. Normally closed AMU solenoid —Blocks the flow of air until power is applied to the solenoid coil. 1 The AGS and AGS2 designations refer to the same Mercedes-Benz transmission. References to AGS2 may be found in ServiceLink ® . Business Class M2 Workshop Manual, Supplement 22, September 2012 050/1