mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Optional Power Switches and Connection 54.39 General Information Introduction feed from the CHM. See Section 54.35 for informa- tion on the junction block marker light feed. Optional power switches are factory-installed, switch- controlled power provisions that can be ordered for a Business Class ® M2 vehicle. Optional switches can be ordered in a one-, two-, or four-switch configura- tion. All optional switches mount on the dash, provide fuse-protected battery power, and route to a cus- tomer access point. Optional switches are commonly used to provide battery-powered lighting, such as dome, spot, or beacon lights.

Other applications in- clude using the optional switch as a triggering mechanism to enable other features, such as hydrau- lic lift operations or access panel locks. For all other optional switch configurations, the out- put circuits from the optional switches route along the chassis toward the back of the cab where the circuits terminate inside the left frame rail near the standard location of the CHM on a vehicle with a day cab. On a vehicle with an extended cab or a crew cab, the circuits terminate under the cab. Output circuits terminate as blunt-cut ends sealed in heat shrink.

The blunt-cut ends extend a few inches out from the harness loom and are individually tagged with an identification label. The label identifies which switch is powering the circuit and also the cur- rent capacity of the circuit. See Fig. 1 . Overview Available optional switch configurations include: one switch with a customer-access junction block one switch with a blunt-cut output two switches with blunt-cut outputs Optional power switches are mounted on the dash to the right of the steering column. Each switch is equipped with two LED lights; one LED provides switch illumination while the other indicates when the switch is in the on position.

Battery-powered power distribution module (PDM) fuses, located under the hood, provide a constant power feed to each switch. When a switch is turned to the on position, the switch contacts close and supply battery power to an output circuit. four switches with blunt-cut outputs 12/21/2005 f544744 Fig. 1, Blunt-cut End Current Capacity It is important to note that the current capacities for optional switch outputs are not the same for all con- figurations. Current capacities differ according to the number of switches that come installed on a vehicle. For instance, for a two-switch configuration, the fused battery feed for both switches is supplied by one PDM fuse.

This means that the total combined load from both switches cannot exceed the fuse rat- ing. For optional-switch current capacities, see Table 1 . For vehicles with a single optional switch and junc- tion block configuration, the output circuit from the optional switch is a red wire that connects to the 5-post junction block. The junction block is usually located on the frame rail near the Chassis Module (CHM) and provides a connection point that permits easy access. The red wire in the junction block is connected to the 15-amp optional switch output, while the yellow wire is connected to a marker light Optional- S witch Current Capacity No.

of Switches PDM Fuse F25 PDM Fuse F26 Switch Output Current Capacity Rating Switch Protected Rating Switch Protected 1 15A Switch 1 15A Business Class M2 Workshop Manual, Supplement 10, September 2006 050/1