mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Optional Power Switches and Connection 54.39 Optional Switch Connections 11. Allow the solder sleeve to cool for a few minutes. 12. Place the heat shrink over the splice and center it as best you can. Then apply 250°F (121°C) to the heat shrink until it has shrunk completely over the wire insulation. Some of the sealant ma- terial should be bubbling out of the ends of the heat shrink. 4 5 3 13. When routing additional electrical wiring, make sure all circuits are properly protected and se- cured. 2 14. Connect the batteries or turn the battery discon- nect switch to the on position. 15. Verify the operation of the electrical feature(s) connected to the optional switch output.

1 6 12/08/2005 f544662 16. Remove the chocks from the tires. 1. Optional-switch Circuit Identification Label 2. Optional-switch Output Wire 3. Frame Rail 4. Back of Cab 5. Crossmember 6. Chassis Module Fig. 2, Optional Switch Outputs 9. Use a suitable crimping tool and the crimp splice from the repair kit to crimp the wires together. 9.1 Insert one of the stripped wire ends into the crimp splice until it touches the wire stop in the center of the crimp splice. 9.2 Center the crimping tool between the wire stop and the end of the crimp splice over the wire. 9.3 Crimp the splice on the wire. 9.4 Check the crimp to be sure that the wire is held in place.

9.5 Repeat the previous substeps for the other wire. 10. Place the solder sleeve over the crimp splice and center the solder ring over the crimp splice. Then apply 250°F (121°C) to the solder sleeve until the solder flows into the crimp splice and the plastic sleeve has shrunk against the wire and crimp splice. Be sure to keep the heat source well away from the heat shrink by sliding the heat shrink at least 4 inches (102 mm) from the splice joint. Business Class M2 Workshop Manual, Supplement 10, September 2006 100/2