mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Cab Heater and Air Conditioner, Valeo 83.00 Troubleshooting and the actuator still does not operate properly, check for mechanical problems with the actuator. To quickly check for normal operation, feel for air flowing from the correct outlet in each air selection setting. Test Conditions Test Point Good Result What to Do if Test Fails Air Distribution Door Actuator Circuit Tests actuator motor drive circuit key on, engine off air distribution door actuator connector removed Measure across pins 5 and 6 of the air distribution door actuator connector. 9V+ for about 1 second * Check wiring between control head and air distribution door actuator. If wiring is okay, replace the control head.

fan (blower) speed on low change the air selection setting while observing the digital multimeter (DMM) actuator position sensor reference voltage circuit key on, engine off Measure between pin 10 of the air distribution door actuator connector and the battery negative post. 5V air distribution door actuator connector removed actuator position sensor reference ground circuit key on, engine off air distribution door actuator connector removed Measure between pin 8 of the air distribution door actuator connector and the battery positive post. 12V * actuator position sensor feedback signal circuit key on, engine off Backprobe pins B10 and B5 at control head connector.

0V (far right) to 5V (far left) Check wiring between control head and air distribution door actuator. all connectors connected If wiring is okay, replace the actuator. * The voltage should be approximately the same as the battery voltage. It is assumed that reference voltage and ground circuits are functioning. Table 4, Air Distribution Door Actuator Circuit Tests Recirculation Door Actuator Circuit Tests switch is in the off position, the recirculation mode is the default mode, but the LED is not illuminated. The recirculation door actuator controls the source of the air, fresh or recirculated, that is routed through the HVAC ducts in the cab.

The recirculation door actuator is controlled by the recirculation button on the control head (climate control panel). When the recirculation mode is enabled, it will remain on until one of the following occurs: the air selection switch is moved to a defrost mode; Vehicles built from May 2, 2003, have partial recircu- lation. For information on this feature, see Sub- ject 050 . the recirculation button is pressed; the ignition is cycled; 20 minutes have passed and the recircu- lation timer has expired. NOTE: On vehicles built prior to May 2, 2003, the recirculation mode is canceled until the re- circulation button is pressed again.

On vehicles built from May 2, 2003, the system enters partial recirculation mode for five minutes, then re- The control rules for the recirculation mode are as follows: The recirculation mode is not available in the defrost settings. The default at power up is fresh air unless the fan switch is in the off position. When the fan Business Class M2 Workshop Manual, Supplement 13, March 2008 300/10