Cab Heater and Air Conditioner, Valeo 83.00 Troubleshooting Temperature Blend Door Actuator Circuit Tests Test Conditions Test Point Good Result What to Do if Test Fails actuator motor drive circuit key on, engine off Measure across pins 5 and 6 of the temperature blend door actuator connector. 9V+ for about 1 second * Check wiring between control head and temperature blend door actuator. temperature blend door actuator connector removed fan (blower) switch on low If wiring is okay, replace the control head.
change temperature setting while observing the digital multimeter (DMM) actuator position sensor reference voltage circuit key on, engine off Measure between pin 7 of the temperature blend door actuator connector and the battery negative post. 5V temperature blend door actuator connector removed actuator position sensor reference ground circuit key on, engine off Measure between pin 8 of the temperature blend door actuator connector and the battery positive post. 12V * temperature blend door actuator connector removed actuator position sensor feedback signal circuit key on, engine off Backprobe pins B11 and B5 at control head connector.
0.50V (full hot) to 4.00V (full cold) Check wiring between control head and temperature blend door actuator. all connectors connected If wiring is okay, replace the actuator. * The voltage should be approximately the same as the battery voltage. Values are approximate. It is assumed that reference voltage and ground circuits are functioning. Table 3, Temperature Blend Door Actuator Circuit Tests Air Distribution Door Actuator Circuit Tests The actuator feedback position has been reached. The air distribution (mode) door actuator controls the direction the air is routed through the HVAC ducts in the cab.
The air distribution door actuator is con- trolled by the air selection switch on the control head (climate control panel). The control head senses the air distribution door position by reading the feedback voltage from the actuator position sensor. The feed- back voltage will be less than the 5V reference volt- age sent by the control head to the sensor. The actuator is stalled for more than 1 second; the actuator feedback position does not change for more than 1 second. The target position corresponds to an end stop and an additional 1 second extra drive in the same direction (to guarantee sealing) has been performed.
The air distribution door should move from one ex- treme position to the other when turning the air se- lection switch from the far left to the far right or from the far right to the far left. The target position is based on the air selection switch setting and internal control head algorithms. The desired position is considered reached when one of the following conditions is true, although this does not necessarily mean that the position actually corresponds to the desired air selection setting (for example, if the actuator movement is limited due to an obstruction). Follow the tests in Table 4 in the sequence pre- sented.
The directions under the column "What to Do if Test Fails" are sometimes dependent on good re- sults from previous tests. If any of the tests fail, stop and perform the specified repair or check. If the air distribution door actuator passes the tests in Table 4 Business Class M2 Workshop Manual, Supplement 13, March 2008 300/9