mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Mercedes-Benz Manual Transmission 26.04 Transmission Removal and Installation 1 01/29/99 f261011 Fig. 12, Capscrews Left in the Timing Case 2 3 flywheel. Taking these precautions will prevent damage to the input shaft, flywheel, and clutch. 15. After making sure that the transmission is firmly secured and well supported, remove the trans- mission from the vehicle. See Fig. 13 . 03/01/99 f261014 1. Transmission 2. Support Plate 3. Jack Fig. 11, Supporting the Transmission 13.3 Using a chain, secure the transmission to the jack. 14. Remove the 16-mm transmission mounting cap- screws that attach the timing case to the bell housing. See Fig. 12 .

14.1 Remove the eleven transmission mounting capscrews. 14.2 After removing the transmission, insert the capscrews into the holes in the timing case, rather than in the bell housing. CAUTION Do not allow the rear of the transmission to drop, and do not allow the transmission to hang un- supported. Keep the flange of the bell housing parallel (all the way around) to the flange of the timing case, until the input shaft is clear of the 01/29/99 f261013 Make sure that the transmission is firmly secured and well supported. Fig. 13, Transmission Ready To Remove Business Class M2 Workshop Manual, Supplement 8, September 2005 100/4