Mercedes-Benz Manual Transmission 26.04 Transmission Removal and Installation 15.1 Pull the transmission and jack straight back until the transmission input shaft is clear of the clutch. 2 3 4 5 15.2 Turn the left-hand front wheel to allow room for the transmission to pass. If nec- essary, lower the jack supporting the transmission. It might also be necessary to jack up the truck to get enough clear- ance to allow the transmission to pass. 1 6 7 IMPORTANT: Watch closely the clearance between the bell housing and the leaf spring. 8 07/25/2005 f261103a 9 10 11 12 15.3 Pull the transmission out through the space behind the front wheel. NOTE: The transmission is shown from the left-hand side. 1.
Transmission Mounting Capscrews 2. Reverse Gear Switch 3. Shift Lever Mounting Bolt 4. Starter Lock Switch 5. Nameplate 6. Output Yoke Pressure Plate Mounting Capscrew 7. U-Joint End Cap Bolts 8. Speedometer Sensor Lock 9. Transmission Fluid Fill Plug 10. Transmission Fluid Drain Plug 11. PTO Mounting Capscrews 12. Clutch Slave Cylinder Mounting Bolts Installation IMPORTANT: Before installing the transmission, make sure that the rear tires are chocked and that the transmission is securely chained to the support plates on the transmission jack. 1. Install the transmission. See Fig. 14 . 1.1 Align the jack and the transmission behind the engine. Fig.
14, Transmission Fasteners 1.2 Raise the transmission and adjust the angle of the jack until the bell housing and the timing case flange are parallel. 40 lbf·ft (54 N·m) and the mounting bolts 95 lbf·ft (129 N·m). 1.3 Push the transmission and jack straight forward. 4. If removed, coat the mating surface of the PTO cover with Loctite ® 509 or equivalent sealing compound. Install the PTO cover on the trans- mission. Tighten the M10 hardened mounting capscrews 43 lbf·ft (58 N·m). Lock the nut retain- ers in place. NOTE: While installing the transmission mounting capscrews, also install the battery cable bracket(s), as removed. 1.4 Install the eleven M10 transmission mounting capscrews.
Use a crossover pat- tern. Do a final tightening of the cap- screws to 33 lbf·ft (45 N·m). 5. Connect the driveshaft. 5.1 Slide the front of the driveshaft into the transmission output yoke. 5.2 Install the U-joint end caps on the output yoke. Tighten the bolt heads 50 lbf·ft (68 N·m) for 3/8-inch end cap bolts and 110 lbf·ft (149 N·m) for 1/2-inch end cap bolts. 1.5 Remove the chain around the transmis- sion and the jack; then remove the jack. 2. Install the exhaust clamp at the exhaust elbow, as removed. 3. If the vehicle is equipped with the optional dual fuel tanks, install the fuel cross-over line and its support between the tanks.
Tighten the clamps 5.3 Install the midship bearing bracket, as re- moved. Tighten the nuts 95 lbf·ft (129 N·m). Business Class M2 Workshop Manual, Supplement 8, September 2005 100/5