Mercedes-Benz Manual Transmission 26.04 Transmission Removal and Installation 6. Install the fuel line standoff bracket and connect the fuel lines to the bracket. 7. Connect the electrical connectors. Connect the electrical cable to the speedometer sensor. Con- nect the electrical connector(s) on the shift lever. 8. Install the shift lever. 8.1 Fit the shift lever over the cone of the transmission tower. f260006b 10/05/94 A B 8.2 Coat the hardened M10 x 20 shift lever mounting bolt with Loctite 242 or equiva- lent thread-locking compound. A. Full B. Low Fig. 15, Transmission Fluid Level Checking 14. Remove the chocks from the rear tires.
8.3 Insert the M10 bolt and a thick washer into the hole in the shift lever. See Fig. 6 . Use the markings made during removal to install the shift lever in the correct orienta- tion, so as to avoid cab floor interference. IMPORTANT: Don’t forget to install the washer. Without the washer, the shift lever may loosen. The driver could lose control of the vehicle. 8.4 Tighten the M10 bolt 50 lbf·ft (68 N·m). 8.5 Work the shift lever around to make sure it shifts comfortably in all gears. 8.6 Install the rubber boot and the metal re- taining ring. Install the four screws and tighten against the cab floor 28 lbf·ft (38 N·m). See Fig. 5 . 9.
Fasten the clutch slave cylinder to the mounting flange on the gear case and tighten the four M8 slave cylinder mounting bolts 15 lbf·ft (20 N·m). 10. If necessary, bleed the hydraulic clutch system. See Section 25.02, Subject 140 for detailed in- structions. 11. Clean the transmission drain plug and install it in the gear case, along with a new aluminum gas- ket. Tighten the drain plug 42 lbf·ft (57 N·m). 12. Add Mobiltrans SHC ® DC until the transmission fluid is level with the lower edge of the fill open- ing. See Fig. 1 for the location of the fill plug and Fig. 15 for checking the correct level. About 9.5 quarts (9.0 liters) is needed. 13.
Clean the transmission fill plug and install it in the gear case, along with a new aluminum gas- ket. Tighten the fill plug 42 lbf·ft (57 N·m). Business Class M2 Workshop Manual, Supplement 8, September 2005 100/6