Mercedes-Benz Manual Transmission 26.04 Shift Mechanism Removal and Installation NOTE: These procedures are for the manual transmission with shift lever only. For the auto- mated AGS transmission, see Sec- tion 26.03, Subject 200 . Installation NOTE: See the installation procedure in Sec- tion 26.03, Subject 200 for more information on the proper alignment of the shift finger in the shift rod. Removal 1. Remove the transmission. For detailed proce- dures, see Subject 100 . 1. Make sure that the indent in the shift rod end (shown by the arrow in Fig. 2 ) is facing aft for proper engagement with the setscrew. 2. Secure the transmission on a wooden pallet, or other device to keep it from moving.
2. Install the shift rod in the front gear case. 3. Make sure the transmission is in neutral. 2.1 Insert the shift rod into the front gear case. 4. Remove the four capscrews that attach the shift rod housing to the flange on the front gear case. See Fig. 1 . 2.2 Turn the shift rod until the dimple is at the 9 o’clock position. 3. Install the shift rod housing on the front gear case. 3.1 Push the housing in until the indent in the rod end is showing in the setscrew hole. 1 3.2 Coat the threads of a new setscrew with Loctite ® 242 or equivalent thread-locking compound. Insert the new setscrew and tighten it 30 lbf·ft (40 N·m). See Fig. 3 .
2 3.3 Install a new shift rod cover in the shift cover housing. 3.4 Position the shift rod housing over the flange in the front gear case. Coat the mating surfaces with a bead of Loctite 509 or equivalent sealing compound. 03/01/2005 3 f261178 1. Front Gear Case 2. Shift Rod Housing Capscrew 3. Shift Rod Housing 3.5 Install the four capscrews that attach the shift rod housing to the front gear case. Coat the threads of the two lower cap- screws with Loctite 242 or equivalent thread-locking compound. Tighten all four capscrews 18 lbf·ft (25 N·m). 5. Remove the shift rod from the front gear case. Fig.
1, Shift Mechanism 5.1 From the right-hand side of the transmis- sion, remove the setscrew that holds the end of the shift rod. Discard the old set- screw. 4. Install the transmission. For detailed procedures, see Subject 100 . 5.2 Remove and discard the shift rod cover from the right-hand side of the gear case. 5.3 Pull the shift rod all the way out of the gear case. Business Class M2 Workshop Manual, Supplement 8, September 2005 110/1