mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Meritor WABCO Pneumatic Antilock Braking System (ABS) 42.00 Testing 6. Turn the ignition switch off. Wheel Speed Sensor Tests 7. If the voltage at the ECU is not within the speci- fied range, check the battery voltage and test the wiring to the ECU and to ground. Wheel Speed Sensor and Circuit Resistance 8. Connect the X1 connector to the ECU and re- move the chocks from the tires. To check the resistance in a wheel speed sensor cir- cuit, perform the following test: ABS Pneumatic System Test 1. Park the vehicle on a level surface, set the park- ing brake, and shut down the engine. Chock the rear tires.

To check for air leaks in the ABS pneumatic system, listen for the sound of escaping air at each valve. To confirm a slow air leak, apply a soap-and-water solu- tion to air line fittings and watch for bubbles. 2. Disconnect the sensor cable connector from the ABS ECU. See Table 1 .

Pin Connector Pin Number Wire Number Circuit Description ABS/ATC Circuit Pin and Wire Numbers 1 376C ECU Ignition Supply 2 376C ECU #2 Positive 12 Volt Supply 3 376T Wheel Spin Light and ATC Switch 4 1587+ J1587+ X1 5 376R Retarder Interrupt Signal 6 1922-/1939- J1922–/1939– Gray 7 1922+/1939+ J1922+/1939+ 9 1587 J1587– 10 376L ABS Light 11 XGRD ECU Ground 12 XGRD ECU Ground 1 Not used 2 378LFI Left Front Modulator Valve, In 3 378RF0 Right Front Modulator Valve, Out 4 378RFI Right Front Modulator Valve, In 5 377RF+ Right Front Sensor, High Black X2 6 377RF– Right Front Sensor, Low 7 377LF– Left Front Sensor, Low 8 377LF+ Left Front Sensor, High 9 378RF– Right Front Modulator Valve, Ground 10 378LF0 Left Front Modulator Valve, Out 11 378LF– Left Front Modulator Valve, Ground 12 Not used Business Class M2 Workshop Manual, Supplement 0, January 2002 170/2