Meritor WABCO Pneumatic Antilock Braking System (ABS) 42.00 Testing ABS/ATC Circuit Pin and Wire Numbers Pin Connector Pin Number Wire Number Circuit Description 1 377LR+ Left Rear Sensor, High 2 377LR– Left Rear Sensor, Low 3 377RR+ Right Rear Sensor, High 4 377RR– Right Rear Sensor, Low 5 378T+ ATC Valve, High X3 6 378T– ATC Valve, Low Green 7 378RR0 Right Rear Modulator Valve, Out 8 378RR– Right Rear Modulator Valve, Ground 9 378RRI Right Rear Modulator Valve, In 10 378LR0 Left Rear Modulator Valve, Out 12 378LRI Left Rear Modulator Valve, In 11 378LR– Left Rear Modulator Valve, Ground Table 1, ABS/ATC Circuit Pin and Wire Numbers 3.
Connect ohmmeter probes to the sensor connec- tor terminals and read the resistance. If the resistance is less than 900 ohms or greater than 2000 ohms, clean the termi- nals and check the resistance again. If the resistance is 900 to 2000 ohms, the cable and the sensor circuit are good. Pro- ceed to the "Wheel Speed Sensor Voltage" test. If the resistance reading is still not correct, replace the sensor. See Subject 110 for instructions. If the resistance is less than 900 ohms or greater than 2000 ohms, perform the next test, "Wheel Speed Sensor Resistance." 4. Install the connectors and remove the chocks from the tires.
Wheel Speed Sensor Resistance Wheel Speed Sensor Voltage To check the resistance in a wheel speed sensor, perform the following test: NOTE: PC diagnostics can be used for this test to compare speed signal output of all sensors. A problem will be indicated by low or erratic out- put. 1. Park the vehicle on a level surface, set the park- ing brake, and shut down the engine. Chock the rear tires. To check the voltage output of a wheel speed sen- sor: 2. Disconnect the wheel sensor cable from the chassis harness. 1. Park the vehicle on a level surface, set the park- ing brake, and shut down the engine. 3. Connect ohmmeter probes to the pins on the sensor and read the resistance. 2.
Chock the tires of the axle not being tested. Raise the vehicle and put jack stands under the axle so the wheels can rotate. If the resistance reading is 900 to 2000 ohms but the resistance noted in the previ- ous test, "Wheel Speed Sensor and Circuit Resistance" was not, repair or replace the chassis harness wiring. 3. Disconnect the applicable connector from the ABS ECU for the sensor being tested. See Table 1 . Business Class M2 Workshop Manual, Supplement 0, January 2002 170/3