mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Meritor WABCO Pneumatic Antilock Braking System (ABS) 42.00 Testing 4. Set a digital multimeter to the AC voltmeter mode. Connect the probes to the cable connec- tor terminals for the sensor being tested. A 5. Rotate the wheel by hand at a speed of 30 rpm (one-half revolution per second) and read the voltage output. The wheel speed sensor must generate a minimum of 0.2 volt AC. 3 1 If the voltage is at least 0.2 volt AC, skip to the next step. B If the voltage reading is less than 0.2 volt AC, push the sensor in its holder until the sensor touches the tooth wheel. See Sub- ject 120 for instructions. Repeat the volt- age test.

2 4 f421562 04/09/97 If the sensor output is still less than 0.2 volt AC, replace the sensor. NOTE: During the self-test, the valves cycle one by one in order (1–2–3–4), then in pairs diagonally (1/2 and 3/4). A 4-channel valve cycle is shown. 6. Install the connector on the ECU. Remove the jack stands, lower the vehicle, and remove the chocks from the tires. A. Cab B. Curbside 1. Right Front Modulator Valve 2. Left Rear Modulator Valve 3. Left Front Modulator Valve 4. Right Rear Modulator Valve Modulator Valve Tests Modulator Valve Function Check Fig. 2, Modulator Valve Self-Test Sequence NOTE:

Valves can be tested using the Meritor WABCO PC Diagnostics software or the follow- ing procedure. 5. If the valves still do not cycle correctly, start the engine and check the air line connections to the valves for leaks. Shut down the engine and tighten the air line fittings. Repeat the self-test. Modulator valves control the air pressure to each af- fected brake during an ABS function. To make sure the modulator valves are working, listen to them cycle during the ABS self-test. 6. If the valves still do not cycle correctly, check for fault codes. Perform the next test, "Modulator Valve and Cable Resistance." 1.

Park the vehicle on a level surface, set the park- ing brake, and shut down the engine. Chock the rear tires. Modulator Valve and Cable Resistance 2. Turn the ignition switch on. To check the resistance in a modulator valve and cable circuit, perform the following test: 3. When the ABS warning light comes on, listen for the modulator valves to cycle one by one, then together diagonally. See Fig. 2 . 1. Park the vehicle on a level surface, set the park- ing brake, and shut down the engine. Chock the rear tires. 4-Channel valve cycle: 1, 2, 3, 4; then 1 and 2 together followed by 3 and 4. 2. Disconnect the modulator valve connector from the ABS ECU. See Table 1 . 6-Channel valve cycle:

1, 2, 3, 4, 5, 6; then 1, 2, and 3 together followed by 4, 5, and 6. 3. Connect ohmmeter probes to the cable connec- tor pins for the modulator valve "In" solenoid and "Ground." Read the resistance. Then, move the probes to the "Out" and "Ground" pins and read the resistance. 4. If the valves do not all cycle correctly, turn the ignition off and check the connectors for tight- ness. Repeat the self-test. Business Class M2 Workshop Manual, Supplement 0, January 2002 170/4