mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Meritor WABCO Pneumatic Antilock Braking System (ABS) 42.00 Testing 4. The resistance in each solenoid coil and cable circuit must be 4 to 8 ohms. If the resistance in each solenoid coil is 4 to 8 ohms but the resistance noted in the previous test, "Modulator Valve and Cable Resistance" was not, repair or replace the chassis harness. If the resistance in each solenoid circuit is 4 to 8 ohms, the cable and modulator valve are good. Install the connector on the ECU and remove the chocks from the tires. If the resistance is less than 4 ohms or greater than 8 ohms, clean the terminals on the modulator valve and check the re- sistance again.

If the resistance in either solenoid circuit is less than 4 ohms or greater than 8 ohms, go to the next test, "Modulator Valve Re- sistance." If the resistance is still not correct, replace the valve. See Subject 130 for instruc- tions. Modulator Valve Resistance 5. Install the cable connectors and remove the chocks from the tires. To check the resistance in the solenoid coils in an ABS modulator valve, perform the following test: 1. Park the vehicle on a level surface, set the park- ing brake, and shut down the engine. Chock the rear tires. ATC Valve Tests ATC Valve and Cable Resistance 2. Disconnect the cable connector from the modula- tor valve being tested. See Table 1 .

To check the resistance in the ATC valve and cable circuit, perform the following test: 3. Connect ohmmeter probes to the modulator valve "In" solenoid and "Ground" terminals and read the resistance. Then, move the probes to the "Out" and "Ground" terminals and read the resistance. See Fig. 3 for the modulator terminal locations. 1. Park the vehicle on a level surface, set the park- ing brake, and shut down the engine. Chock the rear tires. 2. Disconnect the ATC valve connector (X3) from the ABS ECU. See Table 1 . 3. Connect ohmmeter probes to the cable connec- tor pins 5 and 6 for the ATC valve and read the resistance. A 4.

The resistance in the ATC solenoid coil and cable circuit must be 6.4 to 12 ohms. B If the resistance is 6.4 to 12 ohms, the ATC valve and cable are good. Install the cable connector on the ECU and remove the chocks from the tires. 1 2 3 If the resistance is less than 6.4 ohms or greater than 12 ohms go to the next test, "ATC Valve Resistance." 08/30/99 f430143 A. Delivery Port B. Supply Port 1. Ground (Common) 2. Exhaust Solenoid (Out) 3. Supply Solenoid (In) ATC Valve Resistance To check the resistance in the solenoid coil in the ATC valve, perform the following test: Fig. 3, Modulator Valve Terminals 1.

Park the vehicle on a level surface, set the park- ing brake, and shut down the engine. Chock the rear tires. 4. The resistance in each solenoid coil must be 4 to 8 ohms. Business Class M2 Workshop Manual, Supplement 0, January 2002 170/5