Meritor WABCO Pneumatic Antilock Braking System (ABS) 42.00 Testing 2. Disconnect the cable connector from the ATC valve. See Table 1 . 3. Connect ohmmeter probes to the ATC valve ter- minals and read the resistance. See Fig. 4 . 3 2 1 08/30/99 f430144 1. ATC Valve 2. Rear Modulator Valve Assembly 3. ATC Solenoid Terminals Fig. 4, ATC Valve Terminals 4. The resistance of the ATC solenoid coil and its wiring must be 6.4 to 12 ohms. If the resistance is 6.4 to 12 ohms but the resistance noted in the previous test, "ATC Valve and Cable Resistance" was not, re- pair or replace the electrical cable.
If the resistance is less than 6.4 ohms or greater than 12 ohms, clean the terminals on the ATC valve and check the resistance again. If the resistance is still not correct, replace the valve. See Subject 140 for instruc- tions. 5. Install the connectors and remove the chocks from the tires. Business Class M2 Workshop Manual, Supplement 0, January 2002 170/6