Meritor WABCO Pneumatic Antilock Braking System (ABS) 42.00 ABS System Troubleshooting Troubleshooting Tables J1587 Fault Code Cross-Reference Using the following tables, troubleshoot the ABS sys- tem by MID-SID.
MID-SID Description Troubleshooting Table 136-014 Ground Faults Table 10 J1587 Fault Code Cross-Reference 136-015 Table 11 MID-SID Description Troubleshooting Table 136-018 ATC Valve (if equipped) Table 12 Wheel Sensor 136-019 Auxiliary Output Table 13 136-023 ABS Warning Lamp See Subject 310 136-001 Left Front Table 2 136-231 J1939 Datalink Table 14 136-002 Right Front Table 3 136-251 Voltage Table 15 136-003 136-004 Left Rear Right Rear Table 4 Table 5 136-253 Configuration Errors Table 16 136-254 Miscellaneous Faults Table 17 Modulator Valve Table 1, J1587 Fault Code Cross Reference 136-007 Left Front Table 6 136-008 Right Front Table 7 136-009 136-010 Left Rear Right Rear Table 8 Table 9 Left Front Wheel Sensor Troubleshooting (SID 001) MID SID FMI Problem Test Test Result Action 136 001 01 Incorrect sensor air gap 1.
Adjust the sensor. Check the AC voltage across pins 7 and 8 of the black X2 ECU connector while rotating the LF wheel 30 rpm. Voltage is 0.2 Vac or greater Sensor adjustment solved the problem. Voltage is less than 0.2 Vac Check for excessive wheel bearing end play and hub runout. Repair as needed. 136 001 02 Incorrect tire size Check for correct tire size and mixed tire sizes. Check for correct number of teeth on tone wheel. Correct as needed. 136 001 03 Sensor shorted to power 2. Measure the voltage across pins 7 of the X2 (black) connector and a good chassis ground. Repeat the test between pin 8 and ground.
Measurable voltage at either pin Repair short to power in circuit(s) 377LF+ and 377LF– in chassis harness and sensor cable. If problem is in the sensor harness, replace the sensor. No voltage at either pin Repeat the test and check for intermittent short to power in circuits 377LF+ and 377LF–. Suspect ECU is at fault if the problem persists. Business Class M2 Workshop Manual, Supplement 2, June 2002 300/1