mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Meritor WABCO Pneumatic Antilock Braking System (ABS) 42.00 ABS System Troubleshooting Left Rear Wheel Sensor Troubleshooting (SID 003) MID SID FMI Problem Test Test Result Action 136 003 04 Short to ground 3. Measure the resistance between pin 1 of the X3 (green) connector and a good chassis ground. Repeat the test between pin 2 and ground. Resistance between either pin and ground is less than 100,000 ohms Repair the short to ground in circuit(s) 377LR+ and 377LR– in chassis harness or sensor cable. If problem is in sensor harness, replace the sensor.

Resistance between either pin and ground is greater than 100,000 ohms Repeat the test for intermittent short to ground in circuits 377LR+ and 377LR–. Suspect ECU is at fault if the problem persists. 136 003 05 Open circuit 4. Measure the resistance between pins 1 and 2 of the X3 (green) connector. Resistance is 900– 2000 ohms Repeat the test and check for intermittent open or short in circuits 377LR+ and 377LR–. Suspect ECU at fault if the problem persists. Resistance is greater than 2000 ohms OR less than 900 ohm. Perform test 5. 5. Disconnect the sensor connector from the chassis harness. Measure the resistance between the pins on the sensor connector.

Resistance is 900– 2000 ohms Repair open or short in circuit(s) 377LR+ and 377LR– in chassis harness. Resistance is greater than 2000 ohms OR less than 900 ohms Replace the sensor. 136 003 06 Short circuit Perform tests 4 and 5. 136 003 07 Damaged tone ring Inspect tone ring for damage and missing teeth. Make sure correct tooth wheel is installed (100-tooth is normal application). Repair as needed. 136 003 08 Excessive wheel slip Check sensor adjustment. This fault usually occurs when there is excessive tire spin for more than 16 seconds. 136 003 09 Wire mismatch 6. Check for mixed sensor connection. Using Meritor PC Diagnostics, spin each wheel individually.

Check that output is from the correct sensor. Correct wiring connections, as needed. Business Class M2 Workshop Manual, Supplement 2, June 2002 300/6