mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Meritor WABCO Pneumatic Antilock Braking System (ABS) 42.00 ABS System Troubleshooting Left Rear Wheel Sensor Troubleshooting (SID 003) MID SID FMI Problem Test Test Result Action 136 003 10 Intermittent signal 7. Adjust the sensor. Using the wheel sensor output screen in Meritor PC Diagnostics, spin the wheel or drive the vehicle and check for intermittent or erratic signal. Signal output OK Adjustment solved the problem. Make sure brake chatter is not causing the problem. Signal output incorrect Check for intermittent wheel sensor circuit connections. Cause could be due to brake chatter. Repair as needed. 136 003 11 Erratic signal Perform test 7. 136 003 12 Frequency too high 8.

Check sensor wiring and connectors for intermittent contact. Wiring OK Suspect ECU at fault if problem persists. Wiring incorrect Repair wheel sensor circuit, as needed. Table 4, Left Rear Wheel Sensor Troubleshooting (SID 003) Right Rear Wheel Sensor Troubleshooting (SID 004) MID SID FMI Problem Test Test Result Action 136 004 01 Incorrect sensor air gap 1. Adjust the sensor. Check the AC voltage across pins 3 and 4 of the black X2 ECU connector while rotating the RR wheel 30 rpm. Voltage is 0.2 VAC or greater Sensor adjustment solved the problem. Voltage is less than 0.2 VAC Check for excessive wheel bearing end play and hub runout. Repair as needed.

136 004 02 Incorrect tire size Check for correct tire size and mixed tire sizes. Check for correct number of teeth on tone wheel. Correct as needed. 136 004 03 Sensor shorted to power 2. Measure the voltage across pin 3 of the X3 (green) connector and a good chassis ground. Repeat the test between pin 4 and ground. Measurable voltage at either pin Repair short to power in circuit(s) 377RR+ and 377RR– in chassis harness and sensor cable. If problem is in the sensor harness, replace the sensor. No voltage at either pin Repeat the test and check for intermittent short to power in circuits 377RR+ and 377RR–. Suspect ECU is at fault if the problem persists.

Business Class M2 Workshop Manual, Supplement 2, June 2002 300/7