Meritor WABCO Pneumatic Antilock Braking System (ABS) 42.00 ABS System Troubleshooting Right Rear Wheel Sensor Troubleshooting (SID 004) MID SID FMI Problem Test Test Result Action 136 004 10 Intermittent signal 7. Adjust the sensor. Using the wheel sensor output screen in Meritor PC Diagnostics, spin the wheel or drive the vehicle and check for intermittent or erratic signal. Signal output OK Adjustment solved the problem. Make sure brake chatter is not causing the problem. Signal output incorrect Check for intermittent wheel sensor circuit connections. Cause could be due to brake chatter. Repair as needed. 136 004 11 Erratic signal Perform test 7. 136 004 12 Frequency too high 8.
Check sensor wiring and connectors for intermittent contact. Wiring OK Suspect ECU at fault if problem persists. Wiring incorrect Repair wheel sensor circuit, as needed. Table 5, Right Rear Wheel Sensor Troubleshooting (SID 004) Left Front Modulator Valve Troubleshooting (SID 007) MID SID FMI Problem Test Test Result Action 136 007 03 Short to power 1. Measure the voltage between pins 2, 10, and 11 of the X2 (black) connector and a good chassis ground. No voltage at either pin Repeat test. Check circuits 378LFI, 378LFO, and 378LF– for intermittent short to power. Check above circuits for shorts to other modulator valve wires. Repair as necessary.
Inlet or outlet circuit shorted to battery supply or another modulator valve wire. If problem persists, the suspect ECU is at fault. Measurable voltage at either pin Repair short to power in circuit 378LFI, 378LFO, or 378LF–. 136 007 05 Open circuit 2. Check the modulator valve inlet and outlet circuit resistance. Disconnect the connector from the valve and perform the modulator valve resistance test. Resistance in both circuits is within 4 to 8 ohms. Check harness wiring circuits 378LFI, 378LFO, or 378LF–. Inlet or outlet circuit open. Resistance in both circuits is not within 4 to 8 ohms. Replace the modulator valve. 136 007 06 Short to ground 3.
Check the modulator valve inlet and outlet circuit resistance. Disconnect the connector from the valve and perform the modulator valve test. Resistance in both circuits is within 4 to 8 ohms. Check harness wiring circuits 378LFI, 378LFO, or 378LF– for short to ground. Repair as necessary. Inlet or outlet circuit shorted to ground. Resistance in both circuits is not within 4 to 8 ohms. Replace modulator valve. Table 6, Left Front Modulator Valve Troubleshooting (SID 007) Business Class M2 Workshop Manual, Supplement 2, June 2002 300/9