Meritor WABCO Pneumatic Antilock Braking System (ABS) 42.00 ABS System Troubleshooting Right Front Modulator Valve Troubleshooting (SID 008) MID SID FMI Problem Test Test Result Action 136 008 03 Short to power Inlet or outlet circuit shorted to battery supply or another modulator valve wire. 1. Measure the voltage between pins 3, 4, and 9 of the X2 (black) connector and a good chassis ground. No voltage at either pin Repeat test. Check circuits 378RFO, 378RFI, and 378RF– for intermittent short to power. Check above circuits for shorts to other modulator valve wires. Repair as necessary. If problem persists, the suspect ECU is at fault.
Measurable voltage at either pin Repair short to power in circuit 378RFO, 378RFI, or 378RF–. 136 008 05 Open circuit 2. Check the modulator valve inlet and outlet circuit resistance. Disconnect the connector from the valve and perform the modulator valve resistance test. Resistance in both circuits is within 4 to 8 ohms. Check harness wiring circuits 378RFO, 378RFI, or 378RF–. Inlet or outlet circuit open. Resistance in both circuits is not within 4 to 8 ohms. Replace the modulator valve. 136 008 06 Short to ground 3. Check the modulator valve inlet and outlet circuit resistance. Disconnect the connector from the valve and perform the modulator valve test.
Resistance in both circuits is within 4 to 8 ohms. Check harness wiring circuits 378RFO, 378RFI, or 378RF– for short to ground. Repair as necessary. Inlet or outlet circuit shorted to ground. Resistance in both circuits is not within 4 to 8 ohms. Replace modulator valve. Table 7, Right Front Modulator Valve Troubleshooting (SID 008) Left Rear Modulator Valve Troubleshooting (SID 009) MID SID FMI Problem Test Test Result Action 136 009 03 Short to power 1. Measure the voltage between pins 10, 11, and 12 of the X3 (green) connector and a good chassis ground. No voltage at either pin Repeat test. Check circuits 378LRI, 378LRO, and 378LR– for intermittent short to power.
Check above circuits for shorts to other modulator valve wires. Repair as necessary. Inlet or outlet circuit shorted to battery supply or another modulator valve wire. If problem persists, the suspect ECU is at fault. Measurable voltage at either pin Repair short to power in circuit 378LRI, 378LRO, or 378LR–. 136 009 05 Open circuit 2. Check the modulator valve inlet and outlet circuit resistance. Disconnect the connector from the valve and perform the modulator valve resistance test. Resistance in both circuits is within 4 to 8 ohms. Check harness wiring circuits 378LRI, 378LRO, and 378LR–. Inlet or outlet circuit open. Resistance in both circuits is not within 4 to 8 ohms.
Replace the modulator valve. Business Class M2 Workshop Manual, Supplement 2, June 2002 300/10