Meritor WABCO Pneumatic Antilock Braking System (ABS) 42.00 ABS System Troubleshooting Ground Faults Troubleshooting (SID 014) MID SID FMI Problem Test Test Result Action 136 014 04 Low voltage or open circuit 1. Disconnect the X1 (gray) connector at the ABS ECU. With the ignition ON, measure the voltage between pins 1 and 12. Voltage is 9.5 to 14 volts. System voltage is acceptable. Check for intermittent low voltage. Check the batteries and charging system. Voltage may have been temporarily too low. Repair as necessary. Voltage is less than 9.5 volts. Check vehicle batteries and charging system. Check ABS ECU power and ground circuits for open or high resistance. Repair as necessary.
136 014 05 Central group open or high resistance 2. Disconnect the X1 (gray) connector at the ABS ECU. Check the ground circuit (pin 11) for high resistance or open circuit. Ground is okay Verify the fault. Check the ground circuits for open or high resistance. Repair as necessary. Ground is open or has high resistance Repair ground circuit as necessary. 136 014 06 Internal relay does not open If fault repeats, replace the ABS ECU. Table 10, Ground Faults Troubleshooting (SID 014) MID SID FMI Problem Test Test Result Action Ground Faults Troubleshooting (SID 015) 136 015 03 ATC valve grounded to power. 1. Disconnect the X3 (green) connector, check for voltage between pin 6 and ground.
Voltage at pin 6. Circuit 378T- is shorted to power. Locate fault and repair as necessary. No voltage at pin 6. Verify fault. Check for intermittent fault in circuit 378-, repair as necessary. 136 015 04 Low voltage or open circuit 2. Disconnect the X1 (gray) connector at the ABS ECU. With the ignition ON, measure the voltage between pin 2 and a good ground. Voltage is 9.5 to 14 volts System voltage is acceptable. Check for intermittent low voltage. Check the batteries and charging system. Voltage may have been temporarily too low. Repair as necessary. Voltage is less than 9.5 volts Repair voltage supply to ECU. 136 015 05 ATC Valve - High Impedance Replace ABS ECU if fault persists.
06 ATC Valve circuit shorted to ground Disconnect the X3 (green) connector, check resistance between pin 6 and a good ground. Resistance is less than 10,000 ohms Verify fault. Check for intermittent fault in circuit 378-, repair as necessary. Resistance is great than 10,000 ohms Verify fault. Check for intermittent fault in circuit 378T-, repair as necessary. Business Class M2 Workshop Manual, Supplement 2, June 2002 300/12