Meritor WABCO Pneumatic Antilock Braking System (ABS) 42.00 ABS System Troubleshooting Auxiliary Output Troubleshooting (not currently used) (SID 019) MID SID FMI Problem Test Test Result Action 136 019 03 Short to power. This fault should not appear. Re- configure the ECU. If fault continues to appear, check the wiring in the X2 (black) connector. This ABS ECU connector should be unused. Make sure there are no connections to these pins. If incorrect wiring is found, correct it and reconfigure the ECU. If this does not correct the problem, contact Meritor. 136 019 05 Open circuit Verify fault. Contact Meritor WABCO if fault persists. 136 019 06 Short to ground This fault should not appear.
Reconfigure the ECU. If fault continues to appear, check the wiring in the X2 (black) connector. This ABS ECU connector should be unused. Make sure there are no connections to these pins. If incorrect wiring is found, correct it and reconfigure the ECU. If this does not correct the problem, contact Meritor. Table 13, Auxiliary Output Troubleshooting (SID 019) J1939 Datalink Troubleshooting (SID 231) MID SID FMI Problem Test Test Result Action 136 231 02 J1939 speed plausibility error. Check the speedometer calibration. Check for the tire size mismatch. The vehicle speed reported on the J1939 databus does not agree with the wheel sensor speeds. NOTE:
This fault indicates a discrepancy between vehicle speed reported on J1939 and ABS sensed vehicle speed. 136 231 05 J1939 open/short Refer to SB 54-133 for troubleshooting J1939. Repair J1939 datalink as necessary. 136 231 06 J1939 open/short Check the driveline retarder ECU and wires. Check the J1939 Datalink. Repair J1939 datalink as necessary. Code 13s231 05 may be active as well. Freightliner SB 54-133 Business Class M2 Workshop Manual, Supplement 2, June 2002 300/14