Meritor WABCO Pneumatic Antilock Braking System (ABS) 42.00 ABS System Troubleshooting Configuration Errors Troubleshooting (SID 253) MID SID FMI Problem Test Test Result Action 136 253 01 ATC configuration error Check J1939 for proper wiring. Check engine ECU for communication. Repair as necessary, then reconfigure ECU. NOTE: ATC valve is detected without engine datalink (J1939). 136 253 02 ABS configuration/ wheel parameter incorrect. Reconfigure ECU. If fault repeats then the wrong ECU is installed. Replace with the correct ECU. 136 253 12 Check sum error. Check parameter setting. Check if diagnostic device was disconnected during active diagnosis.
Table 16, Configuration Errors Troubleshooting (SID 253) Miscellaneous Faults Troubleshooting (SID 254) MID SID FMI Problem Test Test Result Action 136 254 05 ABS/ATC ECU, no loads No modulator valve connected. Fault may have resulted from end of line test at factory. 136 254 08 Excessive wheel slip. Check wheel speed sensor air gaps. One wheel was much faster than the other. May have been caused by testing vehicle on a dynamometer. 136 254 09 Modulator valve actuated too long. Modulator valve was activated too long (more than 75% of 5 minutes). After a delay, function will return to normal. 136 254 12 Internal error If fault persists, replace the ABS ECU.
136 254 13 Accelerometer out of range If fault persists, replace the ABS ECU. Business Class M2 Workshop Manual, Supplement 2, June 2002 300/16