mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Meritor WABCO Pneumatic Antilock Braking System (ABS) 42.00 ABS Lamp Troubleshooting ABS Warning Lamp Function off, while ground at the instrument cluster pin B11 = lamp on). It also ensures that the lamp will be on if the ABS ECU is disconnected from the vehicle harness. The ABS warning lamp in the instrument cluster warns the driver of a malfunction in the anti-lock brake system. When the system is operating nor- mally, the lamp should come on for a few seconds when the ignition is first turned on, then it should turn off. If a fault occurs in the system, the lamp will illu- minate as long as the fault remains active.

If a wheel sensor fault is repaired or if the system is reconfig- ured, the light will remain on until the vehicle is driven over 4 mph (6.4 km/h). J1587 Message: The ABS ECU can send messages over the J1587 databus to turn the warning lamp on or off. J1939 Message: The ABS ECU can send messages over the J1939 databus to turn the warning lamp on and off. The ABS warning lamp will be illuminated if circuit 376L1 connected to pin B11 at the instrument cluster or if either J1587 or J1939 databus message is broadcast to turn on the lamp. Any one of these will cause the lamp to turn on. See Fig. 1 for ABS lamp wiring. The ABS warning lamp can be controlled by any of the following ways:

By wire (circuit 376L1): The ABS warning lamp is hardwired between the ABS ECU and the instrument cluster through a relay. When the circuit to pin B11 at the instrument cluster is grounded, the lamp will turn on. The ABS ECU will monitor the hardwired lamp circuit for faults (the portion that operates the control side of the relay). NOTE: The relay is used to invert the ground signal between the ABS ECU and the instru- ment cluster (ground at ABS ECU pin = lamp Troubleshooting Tables Business Class M2 Workshop Manual, Supplement 0, January 2002 310/1