Meritor WABCO Pneumatic Antilock Braking System (ABS) 42.00 ABS System Troubleshooting Trailer ABS Warning Lamp Troubleshooting Symptom Possible Cause Action Trailer ABS lamp does not come on when the ignition is turned on. There is no trailer connected or the trailer is not equipped with PLC. The trailer ABS lamp will not illuminate at start-up unless a trailer equipped with PLC is connected to the vehicle. Trailers manufactured on or after March 1, 2001 are equipped with PLC. The vehicle is not equipped with PLC. Verify that the vehicle has PLC. Check the vehicle ABS ECU: WABCO E-Version ABS ECUs have PLC.
Bendix ABS EC-30 ECUs have PLC unless there is a label on it that says "ECU does not control trailer ABS warning lamp." Eaton Gen 5 ABS ECU has PLC. Check if vehicle was manufactured on or after March 1, 2001. The trailer ABS warning lamp bulb is burned-out. Replace the bulb. There is a circuit fault between the tractor ABS ECU and the trailer ABS warning lamp in the dash. Check and correct, if necessary. The trailer ABS warning lamp circuit can be tested at the tractor ABS ECU by grounding the pin to that circuit. This should cause the lamp to illumi- nate. There is faulty wiring (power or ground). Check and correct as necessary. The PLC filter is faulty. Check and replace as necessary.
The tractor ABS ECU is faulty. Be sure to check the trailer ABS lamp circuit and try connecting vehicle to a trailer where PLC is known to work. If the tractor ABS ECU is still faulty, replace. The trailer ABS ECU is faulty. Be sure to check the trailer ABS lamp circuit and try connecting trailer to a vehicle where PLC is known to work. If the trailer ABS ECU is still faulty, replace. Trailer ABS lamp stays on. There is a trailer ABS fault. Refer to the trailer ABS manufacturers literature for troubleshooting. Repair as necessary. Trailer ABS lamp circuit shorted to ground. Repair as necessary.
Table 18, Trailer ABS Warning Lamp Troubleshooting Business Class M2 Workshop Manual, Supplement 2, June 2002 300/19