mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Meritor WABCO Pneumatic Antilock Braking System (ABS) 42.00 ABS Lamp Troubleshooting J1587 Fault Codes (MID 136 SID 023): ABS Warning Lamp Circuit FMI Fault Description Test Test Result Action 05 Open Circuit Test 1: 1. Disconnect the gray X1 connector at the ABS ECU. 12V (approx.) Go to Test 3. 2. Turn the ignition ON. 3. Check for voltage between pin 10 of the X1 connector (harness side) and a known good ground. 0V Go to Test 2. Test 2: 1. Remove the ABS relay.Check for voltage between circuit 81C and a known good ground. 12V (approx.) Go to Test 3. Check circuit 81C be- tween the relay and the BHM. If OK, refer to group 54 for diag- nosing the BHM. 2.

Locate circuit 81C (corresponds to pin 86 of the relay. 3. Turn the ignition ON. 0V 4. Check for voltage between circuit 81C and a known good ground. Test 3: No problem found. Check circuit 376L1 between the ABS ECU and the ABS relay and check circuit 81C for intermittent open cir- cuit. If OK, replace ABS ECU. 1. Remove the ABS relay. 2. Measure resistance across pins 85 and 86 on the relay. 70-90 Ohms Greater than 90 (an open relay coil should result in a reading of 680 Ohms) Replace the ABS relay. Table 1, J1587 Fault Codes (MID 136 SID 023): ABS Warning Lamp Circuit Business Class M2 Workshop Manual, Supplement 0, January 2002 310/3