mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Meritor WABCO Pneumatic Antilock Braking System (ABS) 42.00 ABS Lamp Troubleshooting Diagnosing an ABS Lamp that Remains On Symptom Test Test Result Action Warning Lamp Stays On Test 1: Use Servicelink or Meritor Toolbox to check for J1587 fault codes (MID 136). Yes Go to Test 2. No Go to Test 3. Are there any fault codes? Test 2: Is there an active fault code for the ABS warning lamp circuit? Yes Refer to "Diagnosing Warning Lamp Fault Codes" in this section. (Fault code is MID136 SID 023 FMI 05) No Go to Test 3. Test 3: Did any of the following happen since the vehicle was last driven? The ABS Warning Lamp should go out after the vehicle has been driven over 4 mph (6.4 km/h).

Yes Historic fault codes were cleared. A wheel sensor fault was corrected. The ABS ECU was reconfigured. No Go to Test 4. Test 4: Check the ABS relay, the contacts may be stuck. 1. Remove the ABS relay. 12V (approx) 2. Locate circuit 376L1 that corresponds to relay pin 87A (this is the circuit leading to the instrument cluster. Circuit 376L1 is shorted to ground be- tween the relay and the instrument cluster. Repair as necessary. 3. Turn the ignition ON. 4. Check for voltage between circuit 376L1 at the relay and ground.

0V Table 2, Diagnosing an ABS Lamp that Remains On Since the ABS warning lamp is controlled by three redundant methods, it is unlikely that all three would be inoperative at the same time. If the ABS warning lamp does not turn on when the ignition is switched on, manually ground pin B11 at the back of the in- strument cluster (with connectors plugged in and ig- nition ON). If the ABS warning lamp still does not come on, replace the instrument cluster. Business Class M2 Workshop Manual, Supplement 0, January 2002 310/4