mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Meritor WABCO Hydraulic Antilock Braking System (ABS) 42.26 Troubleshooting Troubleshooting the ABS under normal operation, the ABS ECU will ground circuit 376L at pin 8 of the X2 connector, thus grounding the circuit leading to the instrument cluster and turning the ABS warning lamp on. See Fig. 1 for ABS lamp relay wiring detail. Meritor WABCO TOOLBOX Software The Meritor WABCO TOOLBOX Software can be used to diagnose hydraulic antilock brake system (ABS) faults. This software is packaged and launched from ServiceLink and provides J1587 fault codes and on-screen information to make the neces- sary repairs or replacements. TOOLBOX must be used to reset the ECU memory.

See Meritor WABCO Maintenance Manual No. 39, Rev. 1/00. ServiceLink S22 87a 30 B11 ICU 376L GND 87 376L 81C +12V IGNITION ServiceLink can be used to troubleshoot the Meritor WABCO hydraulic ABS. J1587 fault codes can be read by connecting the vehicle to the ServiceLink computer. J1587 Fault Codes X 2/8 ABS ECU X 2/4 376L1 08/20/2002 f544126 The J1587 fault codes are a combination of the mes- sage identifier (MID), which indicates the ECU or system with the fault (136 for the hydraulic ABS ECU), and the system identifier (SID), which indi- cates the specific component within the system with the fault. The failure mode indicator (FMI) identifies a specific problem with the system component.

See Table 1 for a listing of J1587 fault codes. This table also lists the appropriate troubleshooting table to consult for fault code diagnosis. ABS Warning Lamp Circuit Fig. 1, ABS Lamp Relay Wiring Refer to Fig. 2 to identify a warning lamp condition, then Fig. 3 to diagnose the condition. Make the necessary repairs and clear the fault code from the ECU memory. If more than one fault exists, it will be displayed after the first one has been cleared from memory. A volt ohmmeter (VOM) can determine the condition of the ABS valves, wheel end sensors and associ- ated wiring. Figure 4 displays pin locations at the ECU and Fig. 5 displays pin locations at the ABS modulator valve.

Table 2 and Table 3 display corre- sponding circuit to pin information. IMPORTANT: The ignition switch must be off when connecting or disconnecting the ECU. The ABS warning lamp circuit is controlled by wire alone. It is NOT also controlled by the databus as with pneumatic ABS vehicles. The ABS lamp cir- cuit contains a relay located in the dash. The pur- pose of this relay is to turn on the ABS warning lamp in the instrument cluster should the ABS controller be disconnected from the vehicle harness. NOTE: The blink codes are erased from ECU memory as repairs are made. Once a repair has been made, cycle the ignition to ensure the blink code does not reappear.

If there are any other outstanding faults, the next blink code will be displayed. When the ignition is turned on, the relay is ener- gized. This causes the contact to open the circuit from ground to the instrument cluster (circuit 376L). If the ABS ECU becomes disconnected from the ve- hicles harness, the relay becomes de-energized (the ground provided by circuit 376L1 is now open), thus causing circuit 376L leading to the instrument cluster to be grounded through the relay.

If a fault occurs in If the ABS light does not operate correctly after the ignition is turned on (the light does not come on at all or it does not go out after about 3 seconds), check all circuit breakers in the control unit panel and re- Business Class M2 Workshop Manual, Supplement 4, March 2003 300/1