mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Meritor WABCO Hydraulic Antilock Braking System (ABS) 42.26 Troubleshooting Erasing a Fault from the ECU Memory ON OFF A A NOTE: An active fault cannot be erased until it has been corrected. B Meritor WABCO recommends that you erase all faults from the ECU memory after they have been noted and corrected. OFF Stored faults are erased from the ECU memory by clearing historic faults in ServiceLink or Meritor Tool- box. Reset Memorized (Learned Components) C OFF D OFF The ECU learns whether or not a retarder interrupt circuit is present. Once the ECU has detected a re- tarder circuit, it expects to see it every time the ve- hicle is powered up and will monitor the circuit for faults.

If the ECU senses a resistance on the retarder circuit it will automatically learn that the retarder cir- cuit exists. If an engine retarder circuit does not exist, but the ECU has detected one and is indicating faults, something may have been connected (a multi- meter, etc.) to the retarder circuit during testing. Moisture, faulty circuit wiring, or moving an ECU from one vehicle to another can also cause the ECU to mistakenly detect a non-existent retarder circuit. If necessary, use the "Reset Memorized" command in the Meritor WABCO TOOLBOX Software to clear the ECU memory of this component. For instructions, see Meritor WABCO Maintenance Manual No. 39, Rev. 1/00.

Power Distribution Module Ignition key ON Time 08/19/2002 f040633 A. Normal Condition B. Bulb or Wiring Problem C. Connector, Wiring or ECU (warning light circuit problem) D. ABS Fault Fig. 2, ABS Warning Lamp Conditions place if necessary. Check the wiring to warning light and repair or replace the wiring as needed. When checking the warning light: Replace the bulb; Check for a fault in the warning lamp circuit, use ServiceLink or Meritor PC-based diagnos- tics; The main power distribution module (PDM) is mounted in the engine compartment on the left front quarter fender. See Fig. 6 for the location of Fuse 16, ABS constant battery power. See Group 54 for complete PDM information.

Bulk Head Module The ABS system needs between 9.5 and 14 volts. NOTE: Wire repairs may require the use of spe- cial tools for certain connectors and terminals. See Group 54 for information on special termi- nals and connectors and ordering tools for them. See the wiring diagrams in Specifications 400 when troubleshooting the ABS system. If a fault cannot be repaired or erased from ECU memory, contact your District Service Manager or call Meritor WABCO at 1-800-535-5560.

The Bulkhead Module (BHM) is the primary module of the vehicle electrical system, and controls the op- eration of the other multiplex modules in the system and a variety of other vehicle components either di- rectly or indirectly. Business Class M2 Workshop Manual, Supplement 4, March 2003 300/2 ON ON