Meritor WABCO Hydraulic Antilock Braking System (ABS) 42.26 Troubleshooting J1587 Fault 136-001 Left Front Wheel Sensor MID SID FMI Problem Test Test Result Action Resistance reading between 500 and 2000 ohms Check for intermittent, loose or poor connections in Circuits 377LF+ and 377LF– and repair as necessary. If the problem persists, suspect the ECU is at fault. 2. Measure the resistance across Pins 5 and 8 of the green X3 ECU connector (Circuits 377LF– and 377 LF+). Intermittent open circuit or incorrect sensor resistance Resistance reading below 500 or above 2000 ohms NOTE: This SAE J1587 fault code can also be caused by incorrect or mixed tire size. Also see test 4. Go to Test 3.
136 001 02 Resistance reading between 500 and 2000 ohms Check the wiring between the ECU and the wheel sensor (Circuits 377LF+ and 377LF–). Repair as necessary. Go to Test 4. 3. Disconnect the sensor at the sensor connector. Measure the resistance at the sensor connector (on the sensor side). Resistance reading below 500 or above 2000 ohms Replace the wheel sensor. Incorrect or mixed tire size Correct tire size and size variation does not exceed 16 percent Perform Test 2 and Test 3 if not already done. If the problem is not found, verify the fault and check the ECU. NOTE: This SAE J1587 fault code can also be caused by an intermittent open circuit or incorrect sensor resistance.
Also, see tests 2 and 3. 4. Check for tire size deviation in excess of 16 percent. Mixed tire sizes can cause this fault. 136 001 02 Incorrect tire size or size variation exceeds 16 percent Install the correct size tires. Business Class M2 Workshop Manual, Supplement 4, March 2003 300/10