mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Meritor WABCO Hydraulic Antilock Braking System (ABS) 42.26 Troubleshooting J1587 Fault 136-004 Right Rear Wheel Sensor MID SID FMI Problem Test Test Result Action 1. Adjust the sensor. Check the AC voltage across Pins 6 and 7 of the green X3 ECU connector (Circuits 377RR+ and 377RR–) while rotating the right rear wheel 30 rpm. Voltage greater than 0.2 VAC Sensor adjustment solved the problem. Clear the stored faults and drive the vehicle 4 mph (6 km/h). 136 004 01 Incorrect sensor air gap Voltage less than 0.2 VAC Check for excessive wheel bearing end play. Repair as necessary.

Resistance reading between 500 and 2000 ohms Check for intermittent, loose or poor connections in Circuits 377RR+ and 377RR– and repair as necessary. If the problem persists, suspect the ECU is at fault. 2. Measure the resistance across Pins 6 and 7 of the green X3 ECU connector (Circuits 377RR– and 377RR+). Resistance reading below 500 or above 2000 ohms 136 004 02 Intermittent open circuit or incorrect sensor resistance Go to Test 3. Resistance reading between 500 and 2000 ohms Check the wiring between the ECU and the wheel sensor (Circuits 377RR+ and 377RR–). Repair as necessary. 3. Disconnect the sensor at the sensor connector.

Measure the resistance at the sensor connector (on the sensor side). Resistance reading below 500 or above 2000 ohms Replace the wheel sensor. Resistance reading between 500 and 2000 ohms Check for intermittent, loose or poor connections in Circuits 377RR+ and 377RR– and repair as necessary. If the problem persists, suspect the ECU is at fault. 4. Measure the resistance across Pins 6 and 7 of the green X3 ECU connector (Circuits 377RR– and 377RR+). Resistance reading below 500 or above 2000 ohms Go to Test 5. 136 004 05 Open circuit Resistance reading between 500 and 2000 ohms Check the wiring between the ECU and the wheel sensor (Circuits 377RR+ and 377RR–). Repair as necessary. 5.

Disconnect the sensor at the sensor connector. Measure the resistance at the sensor connector (on the sensor side). Resistance reading below 500 or above 2000 ohms Replace the wheel sensor. Table 7, J1587 Fault 136-004 Right Rear Wheel Sensor Business Class M2 Workshop Manual, Supplement 4, March 2003 300/14