mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Meritor WABCO Hydraulic Antilock Braking System (ABS) 42.26 Troubleshooting J1587 Fault 136-013 Retarder MID SID FMI Problem Test Test Result Action 1. Disconnect the black X2 connector at the ECU. Disconnect the retarder relay. With the ignition ON, measure the voltage between Pin 7 of the black X2 ECU connector and a good chassis ground. Voltage zero Check for an intermittent short to power in Circuit 376R. If okay, ECU may be at fault. 136 013 03 Short to power Voltage not zero Check for a short to power in Circuit 376R. Repair as necessary. 2. Disconnect the black X2 connector at the ECU. Disconnect the retarder relay.

Measure the resistance between Pin 7 of the black X2 ECU connector and relay connector cavity that corresponds to pin 85 of the relay. Check relay coil resistance (should be 60-85 Ohms). If okay, check circuit 81C (power to relay coil) for open. Repair as necessary. Resistance less than 1 ohm 136 013 05 Open circuit Resistance more than 1 ohm Repair open in circuit 376R. 3. Disconnect the black X2 connector at the ECU. Disconnect the retarder relay. Measure the resistance between pin 7 of the X2 connector and a good chassis ground. Resistance is less than 10 Ohms Check circuit 376R for short to ground. Repair as necessary.

136 013 06 Short to ground Resistance is much greater than 10 Ohms Check for intermittent short to ground in circuit 376R. If okay, ECU may be at fault. Table 8, J1587 Fault 136-013 Retarder MID SID FMI Problem Test Test Result Action J1587 Fault 136-014 Power 1. Check for voltage backfeeding to ECU with the ignition off, especially to pins 7/X2 and 10/X2. 136 014 03 Voltage supplied to ECU with ignition OFF Voltage zero Repair as necessary. Check Circuit 376A for an intermittent open circuit. If the problem persists, suspect the ECU is at fault. 2. With the ignition ON, measure the voltage between Pin 3 of the black X2 ECU connector and a good chassis ground.

Repeat between pin 11 and ground. Voltage between 9.5 and 14 volts at both pins. 136 014 04 No voltage supplied to ECU with ignition ON Voltage below 9.5 volts at one or both pins. Check Circuit 376A for an open circuit and check Fuse F16. Repair as necessary. Table 9, J1587 Fault 136-014 Power Business Class M2 Workshop Manual, Supplement 4, March 2003 300/15