mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Bulkhead Module 54.12 Troubleshooting Park Brake (pneumatic) Function Input to CHM from Park Brake Pressure Switch Input to BHM from CHM via J1939 Park Brake Status Output from BHM to ICU via J1939 Park Brake Light Status Closed Engaged On Open Disengaged Off Table 21, Park Brake (pneumatic) Function Description of Fault Action Taken by BHM Park Brake (pneumatic) Function Fault Conditions * CHM transmits J1939 park brake switch status unavailable or in error to the BHM. BHM may transmit J1939 message park brake light status unavailable. * This fault also occurs when the CHM is unable to determine the switch status. This does not necessarily mean that the park brake pressure switch is faulty.

Table 22, Park Brake (pneumatic) Function Fault Conditions Parameters Parameters Parameter Part Number Description Hours Parameter Part Number Description Hours 26-01017-002 Switched Center Pin Power 24 26-01019-005 Exterior Lighting 16,667 26-01019-003 Exterior Lighting 16,667 Table 23, Parameters 26-01019-004 Exterior Lighting 16,667 Wake Circuits Troubleshooting Procedures Test No. Test Procedure Test Result Action 1 Open the "Wake Function" Datalink Monitor template. See Fig. 12 . Yes Check the inputs that are remaining active. Put the system into a sleep state by:

For example, if the driver door switch remains active (open) when the door is closed, check the door switch itself and the circuit wiring. Closing the doors. Turning off the headlight switch. Turning off the hazard lights switch. Repair as necessary. Turning off the ignition switch. Removing your foot from the brake pedal. Are any of the BHM and CHM initiating inputs still in an active state on the template (yellow)? No Go to test no. 2. Business Class M2 Workshop Manual, Supplement 22, September 2012 300/15