mercedes-benz — Mercedes-Benz Automated-Manual Transmissions Troubleshooting Guide

Bulkhead Module 54.12 Troubleshooting Wake Circuits Troubleshooting Procedures Test No. Test Procedure Test Result Action 2 If everything works correctly after meeting the conditions in test no. 1, the system should go to sleep within 60 seconds. The template indicates this when all of the annunciators show an exclamation mark (!) * . Go to test no. 6. NOTE: If the vehicle has one of the following reference parameters, the system will remain awake for 24 hours or longer: 26-01017-002, 26-01019-003, 26-01019-004, or 26- 01019-005. Yes NOTE: This troubleshooting step describes a special circumstance that is not typical of the majority of vehicles. Go to test no. 3.

If the system is not working correctly, one or more of the Wake Circuits in the right column of the "Wake Function" Datalink Monitor template remains active (yellow) after 60 seconds. No Within 60 seconds of meeting the conditions in test no. 1, do all of the annunciators on the template show an exclamation mark (!) * ? 3 In the second column of the template under "Other Module Wake Circuits–Status" is the status of all the annunciators "LOW-Wake" (yellow)? Check the wake circuits between the BHM and the following modules for a short to ground: NOTE: Disregard the annunciators for modules not on the vehicle; these will show an exclamation mark (!) * . Yes CHM EXM Repair as necessary.

SEM No Go to test no. 4. 4 If the B5.D BHM to ICU annunciator status is "ON" in the sec- ond column of the template under "BHM Wake Circuits– Status," continue with this test. If not, go to test no. 5. The wake circuit between the BHM and ICU is shorted to power. Yes Repair as necessary. Disconnect BHM connector B5. Test for voltage on pin B5.D (harness side). Is voltage present? No Go to test no. 5. 5 In the second column of the template under "BHM Wake Circuits–Status," check the status of the annunciator labeled Yes If this is the only active annunciator, replace the BHM.

B1.B BHM to CHM Check the multiplexed modules for ignition circuits that are shorted to power (not powering down when the ignition is off). If no problem is found, the system may not be going to sleep because the BHM is not sending the J1939 go-to-sleep message. Try a test BHM to confirm. B4.H BHM to EXM B6.A2 BHM to SEM . No Is the annunciator status "LOW-Wake" (yellow)? Business Class M2 Workshop Manual, Supplement 22, September 2012 300/16