Bulkhead Module 54.12 Troubleshooting Wake Circuits Troubleshooting Procedures Test No. Test Procedure Test Result Action 6 Starting with the system in the sleep state, activate one of the inputs that initiates a wake, such as opening the driver’s door. Go to test no. 8. If the system is functioning properly, all of the annunciators on the template in the second column should be active (yellow) for ECUs equipped on the vehicle as long as the input remains active. For example, the door is open. Yes Go to test no. 7. NOTE: If the vehicle is not equipped with an SEM or EXM, it is normal for the status of these annunciators to be "!" * .
No Are all of the appropriate second column annunciators active? 7 Which annunciator is not active? B5.D BHM to ICU Replace the BHM. B1.B BHM to CHM Replace the BHM. B4.H BHM to EXM B6.A2 BHM to SEM Any one of the "Other Module Wake Circuits– Status" for ECUs that are on the vehicle. Check for an open in the wake circuit between the BHM and the module that is not showing active. If OK, check power, ground, and the J1939 datalink to the ECU that is not responding. 8 Does the ICU wake up when the door is opened? This is indicated by the odometer being displayed. Yes No problem found. Check the wake circuit between the BHM and ICU for open.
No If OK, check fuse 20 and VBAT2 power supply to BHM B4.G. If OK, ICU may be faulty. * The exclamation mark (!) will show on the versions of this template released with ServiceLink version 4.0 and higher. On templates released in ServiceLink versions prior to 4.0, if the annunciator is flashing, the flashing takes precedence over the status that it is displaying. Table 24, Wake Circuits Troubleshooting Procedures Repair as necessary. Business Class M2 Workshop Manual, Supplement 22, September 2012 300/17