TRAVEL WARNING! 1. Before operating the travel levers, make sure that you know in which direction the machine is pointing. Look at the end of the track assemblies. If the drive motors are visible while sitting in the operator's seat, you are looking at the back end of the track assembly (therefore, you are looking backwards). In this case, the response of the travel levers will be the reverse of normal operation. 2. Before moving, make sure that there are no personnel in the way or on the machine. Sound the horn to alert workers that you are about to move the machine. 3. Be sure the path is clear during travel. 4. Use extreme caution when reversing travel.
Be sure there is a clear path behind the machine. 5. Make sure to operate the travel control levers smoothly to avoid sudden starts or stops. 6. Before leaving the operator's seat, make sure to lock out all control systems and shut down the engine to avoid accidental activation. AUTOMATIC TRAVEL SPEED CONTROL WARNING! Do not change the travel mode while traveling. Always use speed mode "O" when traveling down a slope. It is very dangerous to change to speed modes indicated "I" or "II" while going down a slope. Only change travel mode after coming to a complete stop. Two travel speed ranges can be selected by using the speed selector switch on the control panel (Figure 29).
"O" (LOW) - In this position low travel speed and a higher torque are selected. O "I" (HIGH) - In this position high travel speed and a lower torque are selected. I II "II" (AUTOMATIC) - Setting the control at the "II" position enables the machine to automatically change to a different speed range. This change happens automatically depending on the hydraulic oil pressure in the travel circuit. When hydraulic oil pressure rises, the travel speed is automatically set to low. An example is if the machine is traveling on a flat, solid surface, the higher speed range would be used.
When a slope is encountered, the speed drops and the travel circuit hydraulic pressure rises, causing the control circuit to shift to the higher torque, lower speed range. ARO0030L Figure 29 022-00058E Operation and Maintenance Manual Operation 3-15