daewoo Solar 140LC-V — Engine Speed Control

OPERATING INSTRUCTIONS ENGINE SPEED CONTROL Engine speed can be manually adjusted using the engine speed control dial, Increase engine speed by rotating the control knob clockwise. Decrease engine speed by rotating the control knob counterclockwise. IMPORTANT The engine speed control system has been set at the factory and should not require adjustment as part of routine maintenance. HAOA690L Figure 42 If the engine speed control system should have an electrical malfunction, the engine throttle system can be set for manual operation. Use the following procedure; IMPORTANT If the engine rpm is being manually adjusted, the equipment will not function in its optimum capacity.

Please contact a DAEWOO distributor or service center for repairs. 1. Park on firm, level ground. 2. Lower bucket to ground. 3. Set safety lever on "LOCK" position. 4. Set engine speed control dial to “LOW IDLE." Allow engine to idle for 3 - 5 minutes. 5. Shut down engine. Remove key from starter switch. 6. Attach tag, "DO NOT START" on right-hand work lever (joystick). HAOB920L Figure 43 7. Disconnect control cable (1, Figure 44) by removing nut and spring washer (2) and loosening the nuts (3) holding cable to bracket. 8. Remove nut and spring washer (5, Figure 44) from manual engine control cable (4) and loosen the nuts (10) holding cable to bracket.

Attach manual engine control cable ball joint to hole (6) by using nut and spring washer (5). 9. Start the engine. 10. Display the engine rpm on the instrument panel by pressing the "DISPLAY" button. 3-20 Operation 022-00058E Operation and Maintenance Manual