daewoo Solar 140LC-V — Lifting

Lifting Unknown Weight When loads are not accurately known are to be lifted, the person responsible for the job shall ascertain that the weight of the load does not exceed the machine LOAD RATING CHART at the radius at which it is to be lifted. It is recommended that you feel your way into any lift as a precaution against tip-over. One method is to position the boom at 90° over the side of the machine. Slowly lift the load until it clears the ground. A lift over the side is the most unstable, and as the load is swung into the front zone of the excavator it will become more stable. DO NOT INCREASE SWING RADIUS AFTER THE LOAD IS LIFTED.

SIDE LIFT ZONE SIDE LIFT ZONE REAR LIFT ZONE HAAD3842 Figure 81 DANGER! If a load is picked up from the front zone and swung into the side zone, a tip-over could result causing a deadly or fatal injury. Lifting Known Weight The load chart is the governing factor when lifting known weights. It is recommended that you feel your way into any lift as a precaution against tip-over. When ever possible, lift and swing payloads between the front idler area. Pick and Carry The machine has the ability to pick and carry payloads without added labor. We recommend when traveling with a suspended payload, you evaluate the prevailing conditions and determine the safety precautions required in each case.

The following factors must be considered before attempting to pick and carry a load. Align the boom with the forward direction of machine travel. Maintain this boom position when turning the machine. Turn only when necessary, at the slowest speed, and at a wide turning radius. 1. Use the shortest lifting radius distance possible. 2. Keep the load as close to the ground as conditions will permit. 3. Provide tag lines to prevent load from pendulating. Pendulating can cause a change in radius. A change in radius could exceed the load chart rating or cause a tip-over condition. 4. Govern travel speed to suit conditions. 5. Avoid sudden starts and stops.

3-38 Operation 022-00058E Operation and Maintenance Manual NT ON