OPERATION UNDER UNUSUAL CONDITIONS NOTE: See “Maintenance in Special Conditions” on page 4-68 for other recommendations. OPERATION IN EXTREME COLD If machine is to be operated in extreme cold weather temperatures, certain precautions must be taken to assure continued normal operation. The following paragraphs detail checks to be made to be certain the machine is capable of operating at these temperatures. 1. Check the cooling system for correct antifreeze solution for lowest temperature expected. Carefully inspect cooling system and correct or report any leaks. 2. Keep batteries fully charged to prevent freezing.
If water is added to batteries, run engine at least one hour to mix electrolyte solution. 3. Keep engine in best possible mechanical condition to assure easy starting and good performance during adverse weather conditions. 4. Use engine oil of the proper specifications for the expected temperatures. Refer to the "Lubrication Specifications" of the engine manual for details. 5. Keep fuel tank full at all times. Drain condensation from tank before and after operation. Drain and service fuel filter. To eliminate clogging of fuel filters due to wax crystal formation in the fuel, be sure that the fuel used has a cloud point specification below the lowest expected temperature. 6.
Lubricate entire machine according to "Periodic Service Table and Chart" Section 4, in this manual or lubrication chart on machine. 7. Start engine and allow it to reach normal operating temperature before applying load. A. If mud and ice collects and freezes on any of the moving parts while machine is idle, apply heat to thaw the frozen material before attempting to operate machine. B. Operate hydraulic units with care until they have reached a temperature to enable them to operate normally. C. Check all machine controls and/or functions to be sure they are operating correctly. 8.
An extra outer air filter should be kept in the operator's cab to replace element that could become iced and cause restricted air flow to engine. 9. If cold weather starting aid must be used, see "Engine Starting" COLD WEATHER START portion of this manual. 10. Clean off all mud, snow and ice to prevent freezing. Cover machine with tarpaulin if possible, keep ends of tarpaulin from freezing to ground. OPERATION IN EXTREME HEAT Continuous operation of the machine in high temperatures may cause the machine to overheat. Monitor engine and transmission temperatures and stop machine for a cooling-off period whenever necessary. 1. Make frequent inspections and services of the fan and radiator.
Check coolant level in radiator. Check grills and radiator fins for accumulation of dust, sand and insects which could block the cooling passages. A. Formation of scale and rust in cooling system occurs more rapidly in extremely high temperatures. Change antifreeze each year to keep corrosion inhibitor at full strength. B. If necessary, flush cooling system periodically to keep passage clear. Avoid use of water with a high alkali content which increases scale and rust formation. 022-00058E Operation and Maintenance Manual Operation 3-39