daewoo Solar 140LC-V — Operation In Dusty or Sandy Areas

2. Check level of battery electrolyte daily. Keep electrolyte above plates preventing damage to batteries. Use a slightly weaker electrolyte solution in hot climates. Dilute 1.28 specific gravity electrolyte as issued to 1.20 to 1.24 specific gravity readings at full charge. Recharge batteries whenever they reach a 1.16 specific gravity reading. Batteries self-discharge at a higher rate if left standing for long periods at high temperatures. If machine is to stand for several days, remove batteries and store in a cool place. WARNING! Do not store acid-type storage batteries near stacks of tires; the acid fumes have a harmful affect on rubber. 3.

Service fuel system as directed in "Engine Fuel System" Section 5, of this manual. Check for water content before filling fuel tank. High temperatures and cooling off cause condensation in storage drums. 4. Lubricate as specified in "Periodic Service Chart and Table" Section 4, in this manual or Lubrication Decal on the machine. 5. Do not park machine in sun for long periods of time. When practical park machine under cover to protect it from sun, dirt and dust. A. Cover inactive machine with tarpaulin if no suitable shelter is available. Protect engine compartment, transmission and hydraulics from entrance of dust. B.

In hot, damp, climates corrosive action will occur on all parts of the machine and will be accelerated during the rainy season. Rust and paint blisters will appear on metal surfaces and fungus growth on other surfaces. C. Protect all unfinished, exposed surfaces with a film of preservative lubricating oil. Protect cables and terminals with ignition insulation compound. Apply paint or suitable rust preventive to damaged surfaces to protect them from rust and corrosion. OPERATION IN DUSTY OR SANDY AREAS Operation of the machine can cause dust in almost any area. However, when in predominantly dusty or sandy areas, additional precautions must be taken. 1.

Keep cooling system fins and cooling areas clean. Blow out with compressed air, if possible, as often as necessary. WARNING! Wear goggles when using compressed air. 2. Use care when servicing fuel system to prevent dust and sand from entering the tank. 3. Service the air cleaner at frequent intervals, check air restriction indicator daily and keep dust cup and dust valve clean. Prevent dust and sand from entering engine parts and compartments as much as possible. 4. Lubricate and perform services outlined on current lubrication chart on machine and "Lubrication Chart and Table" Section 4. Clean all lubrication fittings before applying lubricant.

Sand mixed with lubricant becomes very abrasive and speeds wear on parts. 3-40 Operation 022-00058E Operation and Maintenance Manual