10 HOUR / DAILY SERVICE GREASE BOOM, ARM AND FRONT ATTACHMENT PINS (FOR FIRST 100 HOURS) Grease every 10 hours for first 100 hours and every 50 hours thereafter (See page 4-22). NOTE: If the unit has been running or working in water the front attachment should be greased on a 10 hour / daily basis. CHECK ENGINE OIL LEVEL WARNING! Allow the engine to cool before checking the oil level to avoid burns by touching hot engine parts. NOTE: When checking level using a dipstick always remove and wipe it clean before making final level check. Figure 11 1. Shut down engine and wait for 15 minutes. This will allow all oil to drain back to oil pan. 2.
Remove dipstick (1, Figure 11) and wipe the oil off with a clean cloth. 3. Insert dipstick fully in the oil gauge tube, then take it out again. 4. Engine oil level must be between "HIGH" and "LOW" marks on dipstick. NOTE: If oil is above "HIGH" mark on dipstick, some must be drained to return oil to proper level. 5. Add oil through engine oil fill cap (2, Figure 11), if the oil level is below the "LOW" mark. Figure 12 4-12 Inspection, Maintenance and Adjustment 022-00058E Operation and Maintenance Manual