DRAIN WATER AND SEDIMENT FROM FUEL FILTER 1. Open drain valve on bottom of fuel filter and drain water and sediment into a suitable container. NOTE: Dispose of drained fluids according to local regulation. DRAIN WATER AND SEDIMENT FROM FUEL TANK Figure 40 1. Perform this procedure before operating the machine. 2. Drain water and sediment from bottom of fuel tank into a suitable container. NOTE: Dispose of drained fluid according to local regulations. NOTE: Always completely fill fuel tank at end of each workday to prevent condensation from forming on the inside walls of the tank. Figure 41 CHECK ENGINE FAN BELT FOR CRACKS, WEAR AND CORRECT TENSION (AFTER FIRST 50 HOURS) 1.
Inspect after first 50 hours of operation or rebuild, and every 250 hours thereafter. For details, See “Check Engine Fan Belt Tension” on page 4-27. CHANGE ENGINE OIL AND FILTER (AFTER FIRST 50 HOURS) 1. Change engine oil and filter after first 50 hours of operation or rebuild, then every 250 thereafter. For details, See “Change Engine Oil and Filter” on page 4-28. INSPECT THE TRACK ASSEMBLIES FOR PROPER TENSION AND LOOSE, WORN OR DAMAGED PARTS (LINKS, SHOES, ROLLERS, IDLERS) 1. Do a daily walk-around inspection of all components including the track assemblies. Look for missing, damaged or excessively worn parts. See “Track Tension” on page 4-69. 2.
Jack up each track and perform the two speed travel motor test. 022-00058E Operation and Maintenance Manual Inspection, Maintenance and Adjustment 4-25