daewoo Solar 140LC-V — Replace Full Flow Hydraulic Oil Filter (After First 250 Hours)

4. Refill the engine with the correct oil through the oil fill port (Figure 49). Refer to the Lubrication Table of this manual for the recommended oil for the operating conditions. NOTE: See “Fluid Capacities” on page 4-7. for capacity. 5. Start engine and check engine oil pressure warning light. 6. Shut down engine. Look for signs of leaks at filter. Recheck oil level. Figure 49 CHECK OIL LEVEL IN TRAVEL REDUCTION DEVICE (ONE ON EACH SIDE OF UNIT) WARNING! The gear oil is very hot after the machine has been operating. Shut all systems down and allow them to cool. Before fully removing any motor case inspection port plug, etc., loosen the plug slightly to allow pressurized air to escape.

Figure 50 1. Park machine on firm, level ground. 2. Rotate the track until ports (1 and 2, Figure 50) are in their proper positions as shown. 3. Remove oil level plug (1, Figure 50). 4. Check oil level. The oil should be near the bottom of the level plug opening. 5. Add oil through the level plug opening, if necessary. 6. Clean and install oil level plug (1, Figure 50). 7. Repeat this procedure on the other travel reduction device. CHANGE OIL IN TRAVEL REDUCTION DEVICE (ONE ON EACH SIDE OF UNIT) (AFTER FIRST 250 HOURS) NOTE: Drain and refill oil after first 250 hours of operation or rebuild, and every 1,000 hours thereafter (See page 4-40).

REPLACE FULL FLOW HYDRAULIC OIL FILTER (AFTER FIRST 250 HOURS) NOTE: Replace full flow hydraulic oil filter after first 250 hours of operation or rebuild, then every 500 hours thereafter (See page 4-32). 022-00058E Operation and Maintenance Manual Inspection, Maintenance and Adjustment 4-29