daewoo Solar 140LC-V — Change Engine Oil and Filter

5. Do not force the belts into the pulley grooves by prying with a screwdriver or pry bar. This will damage the belt side cords which will cause the belts to turn and result in complete destruction of the belts in operation. 6. Belts on new machines and replacement belts lose their tension as they seat into the pulley grooves. Check the tension of new belts at 50 hour intervals until tension is stabilized and thereafter, every 250 hours. If the tension falls below the required minimum, the belt slips damaging the belts and pulley grooves. NOTE: When operating in abrasive conditions, check tension every 100 hours. CHANGE ENGINE OIL AND FILTER NOTE:

Change engine oil and filter after first 50 hours of operation or rebuild, then every 250 thereafter. WARNING! Do not change oil on a hot engine. Allow the engine to cool down before attempting to change the engine oil and filter to avoid burns by touching hot engine parts. 1. Position a larger container under the engine. Remove cap (1, Figure 47) and install hose (2) to drain the engine oil. Remove hose (2) and install cap (1). NOTE: Dispose of drained fluids according to local regulation. 2. Replace engine oil filter by using filter wrench. The engine oil filter is a spin-on type. See Figure 48. Remove and discard filter. Figure 47 3. Install new filter.

Apply a small amount of oil around filter gasket. Screw filter on head until gasket contacts head, turn filter 1/2 turn more. Figure 48 4-28 Inspection, Maintenance and Adjustment 022-00058E Operation and Maintenance Manual