daewoo Solar 140LC-V — Check Engine Fan Belt Wear

CHECK ENGINE FAN BELT TENSION 10mm /10kg IMPORTANT A loose fan belt can cause engine overheating, poor charging, and/or premature belt wear. A belt that is too tight can cause damage to the water pump, alternator bearing or belt. 1. Inspect every 250 hours. (Inspect after first 50 hours of operation.) HJB5001I Figure 45 2. With the engine shut off, check the tension of the fan belt by pressing downwards on the belt, midway between the fan pulley and alternator pulley. The belt should flex approximately 10 mm (0.500 in). See Figure 45. To adjust the belt, loosen the alternator adjustment plate bolts, adjust the belt tension and retighten the bolts. CHECK ENGINE FAN BELT WEAR WARNING!

Keep clear of engine fan and fan drive belts when the engine is running. Rotating fan and belt contact can cause injury. WARNING! When checking, adjusting or replacing drive belts, care must be taken to prevent accidental cranking of the engine. Be sure the starter switch is in the "OFF" position and the controls are tagged. Figure 46 1. Replace badly worn, greasy or severely cracked belts immediately. These conditions prevent proper belt function. Visually inspect the belt. Check the belt for intersecting cracks. Transverse (across the belt width) cracks are acceptable. Longitudinal (direction of belt length) cracks that intersect with transverse cracks are not acceptable.

Replace the belt if it is frayed or has pieces of material missing. 2. Before installing new belts, make sure all pulley grooves are clean and not worn. Replace pulley, if damaged, or if the grooves are worn. 3. All pulley support bearings, shafts, and brackets must be in working order. 4. When replacing belts and pulleys, pulley alignment must be checked with belts tensioned and brackets securely clamped. A misalignment that can be detected by the naked eye is detrimental to belt performance. 022-00058E Operation and Maintenance Manual Inspection, Maintenance and Adjustment 4-27