500 HOUR / 3 MONTH SERVICE PERFORM ALL DAILY, 50 AND 250 HOUR SERVICE CHECKS GREASE SWING GEAR AND PINION 1. Remove inspection cover and inspect the condition of the grease. Make sure that water or other contaminants are not noticeable. NOTE: The upper structure must be rotated a little at a time so that the entire face of the swing gear can be lubricated. Use extreme caution when performing this operation. Figure 51 2. If water or other contaminations are found, remove the lower access cover so that the gear teeth can be thoroughly cleaned and lubricated. 3. Install access covers after lubricating gear teeth.
Figure 52 022-00058E Operation and Maintenance Manual Inspection, Maintenance and Adjustment 4-31