1. Slowly open the radiator cap to allow any pressure to escape. 2. Place a container under the radiator and open the drain valve (Figure 73). NOTE: Dispose of drained fluids according to local regulation. Figure 73 3. Open heater shut-off valves (Figure 74) to allow coolant to drain from heater core. Figure 74 4. Remove coolant drain plug (1, Figure 75) from engine. 5. Install drain plug, and close drain valve after coolant has completely drained from system. 6. Fill cooling system with a flushing solution. 7. Run engine at low idle until the engine coolant temperature gauge reaches the "GREEN ZONE." Run engine for another 10 minutes. 8. After allowing engine to cool. Figure 75 9.
Drain flushing fluid and fill system with water. 10. Run engine again to allow water to completely circulate. 11. Drain water and fill system with proper antifreeze mixture for ambient temperature. Refer to coolant concentration table. (See page 4-63) 12. Run engine without radiator cap installed, so that all air will be purged from system. Fill radiator to fill neck. 13. Drain and fill radiator coolant recovery tank. 022-00058E Operation and Maintenance Manual Inspection, Maintenance and Adjustment 4-45