daewoo Solar 140LC-V — Hydraulic Oil Exchange and Suction Strainer Cleaning

HYDRAULIC OIL EXCHANGE AND SUCTION STRAINER CLEANING WARNING! The hydraulic oil will be hot after normal machine operation. Allow the system to cool before attempting to service any of the hydraulic components. The hydraulic tank is pressurized. Loosen the air breather cap to allow the pressurized air to vent. After the pressure has been released, it is safe to remove either the fill cap or service covers. ARO1760L Figure 76 IMPORTANT Make sure to clean any dirt or water from the top of the hydraulic tank, especially around the fill port and filter ports. Hydraulic oil change interval is 2,000 hours, only when Daewoo Genuine Oil is used.

If other brands of oil is used, guaranteed change interval is 1,000 hours. NOTE: Based on the type of excavating being completed, the working conditions (extremely hot or dusty) and the extra front end attachments being used (hydraulic breaker, etc.), the hydraulic fluid will need to be changed more frequently. 1. Position the machine on firm, level ground. Swing upper structure perpendicular (90°) to tracks. Lower boom and position bucket on ground as shown in Figure 77. 2. Set safety lever on "LOCK" position. 3. Shut down engine. 4. Release pressurized air from hydraulic tank by rotating air breather cap (1, Figure 80).

HAOC390L Figure 77 4-46 Inspection, Maintenance and Adjustment 022-00058E Operation and Maintenance Manual