daewoo Solar 140LC-V — Bucket Tooth Replacement

BUCKET BUCKET TOOTH REPLACEMENT WARNING! Due to the possibility of flying metal objects, always wear safety helmet, protective gloves and eye protection when changing bucket teeth. Curl the bucket upwards and place the round rear surface of the bucket firmly on the ground. Shut the engine off and lock out the hydraulic controls before working on the bucket. NOTE: These instructions are only for Daewoo OEM buckets. If you are using other manufacturers buckets, refer to their specific instructions. Figure 81 HAOC680L 1. On a routine basis, inspect bucket teeth to make sure that tooth wear or breakage has not developed.

Do not allow replaceable bucket teeth to wear down to a point that bucket adapter is exposed. See Figure 81. 2. To replace a tooth (1, Figure 82), use a hammer and punch to drive locking pin (2) and lock washer (3) out of tooth adapter (4). 3. Once worn tooth has been removed, use a putty knife to scrape adapter as clean as possible. Figure 82 4. Slide new tooth into position and insert lock washer. 5. Insert locking pin into tooth and with a hammer, drive pin in until lock washer seats in locking groove. 4-54 Inspection, Maintenance and Adjustment 022-00058E Operation and Maintenance Manual