daewoo Solar 140LC-V — Fuel Transfer Pump (Option)

FUEL TRANSFER PUMP (OPTION) WARNING! 1. Do not dry operate fuel pump for more than 15 seconds. Cooling and lubrication of pump is achieved by fuel passing through pump. If pump is dry operated, heat generated by moving parts will cause damage to pump rotors, vanes and seals. To prevent unnecessary wear and/or damage to pump do not dry operate fuel pump for more than 15 seconds. 2. Do not operate pump for more than 15 minutes at a time. Continuous usage of pump over recommended time interval will cause overheating of motor and will result in causing motor damage. 3. Do not use refueling pump for other types of fuel or fluids.

(Use only for diesel fuel.) Do not use refueling pump for other types of fuel which have a low flash point. Do not use refueling pump for fuel contaminated with water or high humidity. Moisture in pump mechanism can cause rust and can create pump failure. 4. Always operate pump using strainer installed on inlet hose. This will prevent any foreign materials from being introduced into pump. Always maintain pump and all of its components in a clean condition. If dirt or other foreign materials enter pump, it can become lodged between the rotor and/or vanes and generate heat which can cause pump damage. Do not remove strainer or use a strainer with larger mesh to increase flow of fuel. 5.

Be careful not to overfill or spill fuel. 6. Make sure direction of check valve is in line with flow direction of fuel. 7. If any pump parts or components become lost, damaged or inoperable, immediately replace it with a new ones. IMPORTANT If there are any sign of leakage while operating transfer pump, inspect the following components to prevent any fires or hazardous fuel spills. Check all hoses leading to and from the transfer pump. Check all hose clamps. Check transfer pump inlet port. The transfer pump is used to transfer fuel from a refueling source to the fuel tank. A check valve is installed in the inlet hose to prevent fuel from flowing back from fuel tank to source.

A strainer is installed in inlet hose to prevent any foreign material from being introduced into transfer pump or fuel tank. A thermal limiter, built into the motor, will automatically shut off power if motor is overheating to protect it from damage. 4-64 Inspection, Maintenance and Adjustment 022-00058E Operation and Maintenance Manual