FUEL FUEL TANK 5 HAOP551L Figure 93 1. BODY 2. CHECK VALVE 3. STRAINER 4. STRAINER CAP 5. INLET HOSE 1. Remove strainer cap (4, Figure 93) from strainer (3) on end of inlet hose (5). NOTE: Keep strainer cap (4, Figure 93) in a safe location to reseal strainer (3) after refueling is complete. 2. Insert inlet hose (5, Figure 93) into refueling tank. 3. Turn fuel pump switch (Figure 94) inside of battery box on front side to “ON” position. NOTE: Transfer pump rate of flow is approximately 35 liters/minute (9.24 U.S. gpm). Use extra care not to overfill fuel tank so that fuel does not over flow. Figure 94 4. Once fuel transfer is completed, immediately turn switch to “OFF” position to stop pump.
5. Lift inlet hose (5, Figure 93) from fueling source and turn switch to “ON” position for 2 - 3 seconds to drain remaining fuel from hose to fuel tank. 6. Install strainer cap (4, Figure 93) on inlet strainer (3) and return hose (5) to storage position. 022-00058E Operation and Maintenance Manual Inspection, Maintenance and Adjustment 4-65